|
|
03-07-2010, 01:21 PM | #1 |
Enlisted Member
5
Rep 47
Posts |
Front license plate bracket
Live in Va and must run the dreaded front license plate bracket. Just mounted the "gomingo" no hole bracket. It's offset, it works, but it's kinda ugly. It's probably the look of off center and sticking out on one side.
Anyone have a photo of the OEM bracket that BMW dealer puts on? I might have to go ahead and drill to center for a better look. Looked at the Skene web site too but no current photo's of their bracket mounted on an E89. Thanks |
03-07-2010, 02:48 PM | #2 |
Lieutenant Colonel
91
Rep 1,838
Posts |
__________________
|
Appreciate
0
|
03-07-2010, 02:59 PM | #3 | |
Private First Class
11
Rep 162
Posts |
Quote:
Wish I new about this before I drilled my bumper. JZ |
|
Appreciate
0
|
03-07-2010, 04:55 PM | #4 | |
Major
53
Rep 1,162
Posts |
Quote:
__________________
Colonel (Retired), US Army/Hagerstown, MD
2016 518ixdrive/MSport AW/Ivory White ED-01-10 2010 Z4s30i AW/Beige/Burl/ 6MT/SP/PP/CWP/NAV/ipod/USB/CA (retired) 2011 335d BS/Oyster/PP/CWP/NAV/ipod/USB(Daily Driver) 30+ mpg(retired) |
|
Appreciate
0
|
03-07-2010, 07:08 PM | #7 |
Lieutenant Colonel
91
Rep 1,838
Posts |
I've never used these, so I don't know if they're good, however if you take a look the plugs, they don't look anything special, you could try going to home depot and finding plastic fasteners and paint them yourself.
http://www.**********s.com/Painted_B...ectors_BMW.htm http://www.bumperplugs.com/
__________________
|
Appreciate
0
|
05-07-2010, 09:17 AM | #8 | |
Private
7
Rep 71
Posts |
Quote:
I'm trying to decide what to do wrt front plates. |
|
Appreciate
0
|
05-07-2010, 10:16 AM | #9 |
Major General
1910
Rep 5,105
Posts |
dwagner,
Go to http://www.gominigo.com/NHLPB-BMW.html and scroll down until you see the Z4-E89 model with the Ontario license plate - that's MY CAR!! Ordered from gominigo about a month or so ago, installe about 2 week ago. Dave |
Appreciate
0
|
05-07-2010, 10:25 AM | #10 | |
Captain
71
Rep 886
Posts |
Quote:
Hey DW, Don't even bother with the front plate, the cops don't seem to care in these parts. I've been driving my MB for 6 years here without one and I have no plans of messing up the front of the new car with one either. Even when I got a speeding ticket down in the Portland area they didn't care..., it's just not a part of their priorities as long as the rear is properly displayed. |
|
Appreciate
0
|
05-07-2010, 11:24 AM | #11 | |
New Member
0
Rep 17
Posts |
Quote:
It would be alot better if the car were designed to better accomodate the us plates (or if US plates changed to match elsewhere). As it was I had to tell the dealer to mount the bracket lower than it it was designed to go so that the plate didn't come up over the bottom of the kidney grilles. |
|
Appreciate
0
|
05-07-2010, 11:52 AM | #12 |
Colonel
381
Rep 2,588
Posts |
|
Appreciate
0
|
05-07-2010, 11:54 AM | #13 | |
Enlisted Member
0
Rep 32
Posts |
Quote:
|
|
Appreciate
0
|
05-07-2010, 11:54 AM | #14 |
Private First Class
14
Rep 168
Posts |
Take a look at this:
http://www.bimmerpost.com/2010/05/03/look-ma-no-holes/ I would get a front license plate installed no matter what. Just in case. Last edited by MDLFCS; 05-07-2010 at 12:01 PM.. |
Appreciate
0
|
05-07-2010, 11:56 AM | #15 | |
Private
7
Rep 71
Posts |
Quote:
What measurements did you send them? |
|
Appreciate
0
|
05-07-2010, 11:58 AM | #16 | |
Private
7
Rep 71
Posts |
Quote:
I'll probably buy something from gominigo just to be able to quickly mount it if needed. |
|
Appreciate
0
|
05-07-2010, 12:31 PM | #18 |
Colonel
381
Rep 2,588
Posts |
i refuse to drill the front bumpers of our BMWs but it is the law in TX (front plate required); i am sure that eventually i will get a ticket for this but so far so good, knock on wood
|
Appreciate
0
|
05-07-2010, 12:58 PM | #19 |
Major General
1910
Rep 5,105
Posts |
DW, I orderd the one marked '2009+' and it definitely will fit the MY10 & MY11 (mine's a 2011). Also ordered the offset bracket too.
Yes, it's the light gray / silver. Hope that helps! Dave Last edited by BMWZ4; 05-07-2010 at 01:00 PM.. Reason: Left out the color of the car |
Appreciate
0
|
01-31-2012, 08:39 PM | #20 | |
Registered
0
Rep 4
Posts |
This is perfect, Thanks
Quote:
|
|
Appreciate
0
|
01-31-2012, 09:17 PM | #21 |
Private First Class
53
Rep 178
Posts
Drives: Z4 3.5i MSport manual, 2020X3M
Join Date: Nov 2006
Location: Midwest USA
|
Front bracket, we don't need not stink'n brackets.
How about 3M double stick tape. It is what BMW used to attached my front plate for Euro delivery. Sticking just fine for over 8 months now. If and when it gets loose I can reapply fresh tape. Just an alternative to funky mounts, or drilling holes.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|