View Single Post
      07-15-2017, 08:02 AM   #33
fmorelli
Lieutenant
fmorelli's Avatar
United_States
160
Rep
561
Posts

Drives: Atacama Yellow 35i
Join Date: Mar 2016
Location: VA

iTrader: (0)

jts1981 suggestion of the stainless steel wire ties is good. When I was doing it I didn't have those yet, and used a black plastic wire tie, which has held up for a year. I'll replace it with the stainless ones I now have. Here are a couple photos, as my car is up in the air right now.

In the photos you can see I have two wire ties being used: one tie is just on the arm, but prevents the mount from walking down the arm. The second photo shows a wire tie acting as a clasp. When you pop the mount off the regular arm, it is not big enough to clasp the M3 arm. I just ran the wire tie through the two slots and tugged.

Hmmm come to think of it I'll replace these with the stainless ones while the car is up in the air.

Filippo



__________________
2011 35i MT Atacama ... lots of bits. Full Öhlins TTX custom suspension. Build thread.
Build sheet. Currently finishing suspension, fuel, ignition system with Barry Battle @ 3DMMotorsport.
Appreciate 0