New 2009 2010 BMW Z4 - ZPOST
BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read

Go Back   New 2009 2010 BMW Z4 - ZPOST > BMW Z4 Forum (E89) > 2009-Current Z4 Forum (E89) General Discussion

Post Reply
Thread Tools Search this Thread
      01-30-2014, 05:21 PM   #1
First Lieutenant
Drives: 2010 z4 3.0 crimson red
Join Date: Sep 2009
Location: austin, tx

Posts: 318
iTrader: (0)

eccentric shaft sensor replaced

2010 3.0 z4 with 45k miles.

For the last few months i noticed cold start shaking and random idle rpm's. finally got around to pulling the codes on it. here is a partial list:


took it to the dealer and yes the oil got past the ring and into the sensor. that sensor is located in a not so easy spot so labor took almost all day. fortunately warranty covered it. unfortunately, i don't believe they have redesigned any of the parts so it will happen again at a later date. lots of threads on the internet about this sensor failure.

just an fyi, the above codes, even though there were multiple instances of them, never cause the check engine light or service light to come on.
mikeinaustin is offline   United_States
Reply With Quote
Post Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -5. The time now is 01:16 AM.

Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.,,,,,,,,, logo and trademark are properties of BIMMERPOST