New 2009 2010 BMW Z4 - ZPOST
BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read


Go Back   New 2009 2010 BMW Z4 - ZPOST > BMW Z4 Forum (E89) > Engine, Transmission, Exhaust, Drivetrain, ECU Software Modifications

Post Reply
 
Thread Tools Search this Thread
      06-20-2011, 03:31 AM   #1
al1
Private
5

 
Drives: z4 35i
Join Date: Aug 2010
Location: Istanbul / Turkey


Posts: 86
iTrader: (0)

BMS DCI

I installed the dual cone intake and drove the car about an hour or so to see how it is. Overall it is very beneficiary. It sort of minimized turbo lag between shifts and added up some power that you can actually feel. In addition, there is this really nice sound on high raves due to extra air induction.

My only concern is about the engine temperature. Before the installation, it used to sit right below 100 C but now it is up to 120 and at wot it goes maybe little bit above that. I dont know if that is going to have any negative impact, I am going to observe for a while .. but man I loved the sound it ...

Appreciate 0
      06-20-2011, 05:18 AM   #2
Constant.S
Resistance is futile...
23

 
Constant.S's Avatar
 
Drives: BMW Z4 E89(N54) Porsche 997 4S
Join Date: Nov 2010
Location: Greece/Canada


Posts: 615
iTrader: (0)

Send a message via MSN to Constant.S Send a message via Skype™ to Constant.S
In the long run you lose power due to heat soak. It has been logged and proven in the E90/N54 section of the forums but if you like the sound the car makes and dont mind minimal power losses then stick with them
__________________
An ounce of performance is worth pounds of promises.
Appreciate 0
      06-20-2011, 05:36 AM   #3
al1
Private
5

 
Drives: z4 35i
Join Date: Aug 2010
Location: Istanbul / Turkey


Posts: 86
iTrader: (0)

hmmm definitely i would mind any power loss.. but now it feels more powerful than before :S i might be wrong as well, i guess gotta see after driving it for a while
Appreciate 0
      07-05-2011, 02:53 PM   #4
sDrive35i
Private
5

 
Drives: 2011 Z4 sDrive35i
Join Date: Jul 2011
Location: Brooklyn


Posts: 91
iTrader: (0)

How much power loss?
__________________

2011 BMW Z4 sDrive35i
2010 Nissan Maxima
Appreciate 0
      07-05-2011, 05:55 PM   #5
ridin135
Colonel
79

 
Drives: 991 C2S & E92 M3
Join Date: Dec 2008
Location: Greenville


Posts: 2,259
iTrader: (7)

Quote:
Originally Posted by sDrive35i View Post
How much power loss?

If you are running low boost in city driving there is a slight power loss. But you gain a good amount in high boost applications. If you run methanol you should be running the dci because the stock intake is a bottle neck.
Appreciate 0
      07-06-2011, 04:59 AM   #6
al1
Private
5

 
Drives: z4 35i
Join Date: Aug 2010
Location: Istanbul / Turkey


Posts: 86
iTrader: (0)

after driving it couple weeks, i havent noticed any power loss. i drive mostly in the city for short distances and my car is bone stock except the dci...
but i gotta admit the sound of the intake is nice. it is not too loud but at high rpms it is sweet..
Appreciate 0
      07-10-2011, 07:25 PM   #7
persian54
Lieutenant General
United_States
642

 
persian54's Avatar
 
Drives: SL550. Prev: E93 M3/335i/Z435i
Join Date: Jun 2009
Location: The Valley, SoCal


Posts: 15,807
iTrader: (291)

Quote:
Originally Posted by al1 View Post
after driving it couple weeks, i havent noticed any power loss. i drive mostly in the city for short distances and my car is bone stock except the dci...
but i gotta admit the sound of the intake is nice. it is not too loud but at high rpms it is sweet..
why not get a tune?
Appreciate 0
      08-21-2011, 06:46 PM   #8
335iJWC
~~~
United_States
16

 
Drives: JB 335i-M3
Join Date: Feb 2010
Location: Simi Valley


Posts: 590
iTrader: (4)

Garage List
2008 BMW 335i  [4.50]
Tune it! and youll definetly make use off the DCI.
Appreciate 0
      09-01-2011, 09:57 PM   #9
z4z4z4
Lieutenant
United_States
28

 
z4z4z4's Avatar
 
Drives: 2002 M3, 2011 Z4, & her 740Li
Join Date: Mar 2010
Location: mild mediterranean breezes


Posts: 534
iTrader: (1)

Doesn't hurt to provide some additional fresh air to the DCIs.
http://performanceunlimited.com/cobr...n/ductfan.html

The smallest fan ( I have not purchased yet) will help with a delivery of 140 cfm. Again, it doesn't hurt to provide more fresh air, whether you "pump" it to the filters or allow ram-effect at speed. Increase of air mass is the power provider and the FMIC is in place to handle the real heat load.
Attached Images
   
__________________

BBS-ER-HPF-iJDM-LUX-MachtSchnell-PSS-Remus-Tekarbon
Appreciate 0
      09-02-2011, 08:52 AM   #10
ZheHbKa
Lieutenant Colonel
Russian Federation
45

 
ZheHbKa's Avatar
 
Drives: the Wind
Join Date: Jul 2007
Location: NYC


Posts: 1,795
iTrader: (0)

Garage List
2014 BMW 335 Xi  [5.00]
cool setup, how stable is the hose by the intake side?
__________________
2014 F30 335 X-Drive | 6-MT | Alpine White/Coral Red | ZMM ZDH ZDA |

Appreciate 0
      09-02-2011, 10:58 AM   #11
z4z4z4
Lieutenant
United_States
28

 
z4z4z4's Avatar
 
Drives: 2002 M3, 2011 Z4, & her 740Li
Join Date: Mar 2010
Location: mild mediterranean breezes


Posts: 534
iTrader: (1)

Thanks for naming it "cool set-up". The 8" collector at the inlet has a bracket attached to the 10mm bolt for one of the horns and there is foam around top, bottom and outboard sides of collector. Stable. I set a fan on the ground in front of the inlet and was encouraged with the 2 1/2" hose flow.
Attached Images
 
__________________

BBS-ER-HPF-iJDM-LUX-MachtSchnell-PSS-Remus-Tekarbon
Appreciate 0
Post Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:56 AM.




zpost
Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST