|
|
09-15-2011, 06:13 PM | #1 |
Enlisted Member
3
Rep 42
Posts |
Smarttop error! HELP!
Hi guys,
I just installed my smarttop for my e89 and the LED does blink green steadily. However, when I tried to use the remote for the features. Nothing happens...What can be the problem? I did update all the firmware updates before I did the installation. Do I need to program the module to my remote or something? If so, please let me know how. Thank you |
09-15-2011, 07:48 PM | #3 |
Enlisted Member
3
Rep 42
Posts |
hmm good question, i will try that, thank you!
how do I get the signal stalk to program mode? tried to follow the directions but aint working...I dont want to replace all the plastic/carpet pieces again... |
Appreciate
0
|
09-15-2011, 08:22 PM | #4 |
Private First Class
3
Rep 120
Posts |
I left a USB cable connected so I can always connect the computer to reprogram the module.
But I just went out to the car to test the manual programming technique and it worked fine for me: Get in the car insert the key start the car stop the car remove the key press down the turn signal stalk (but not past the click) the left turn arrow should blink once (after a short time) Now follow the programming as per the instructions. When finished, insert the key and both arrows should light up remove the key, you are done. HTH Last edited by bjarne; 09-15-2011 at 08:44 PM.. |
Appreciate
0
|
09-16-2011, 01:14 AM | #5 |
Lieutenant General
923
Rep 15,818
Posts |
you're not suppose to start start the car, just get it where your gauges are working.
don't need to get the engine going
__________________
|
Appreciate
0
|
09-16-2011, 01:27 AM | #6 | |
Private First Class
3
Rep 120
Posts |
Quote:
Anyway, it might not be necessary, but I showed a way that I verified works |
|
Appreciate
0
|
09-16-2011, 02:43 AM | #7 | |
Major
85
Rep 1,448
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|