|
|
02-28-2016, 06:23 AM | #1 |
Enlisted Member
1
Rep 31
Posts |
Dash Command
Afternoon folks,
Im using Dash Command to attempt to data log. Couple questions and points:- *Am i wasting my time - are results accurate ? *When i logged car running RC ultimate on setting D - it showed 18.4psi / 312 hp / 333 lb-ft / Im now running on setting 0 (3 levels above D) but the readouts are way lower. Im presuming the software is not accurate or it cannot properly read data with direct tap in boost sensors ect. My but dyno tells me power is increasing but the dashcommand tells me otherwise. Any help or info appreciated Jamie |
03-02-2016, 07:56 AM | #2 |
Private First Class
37
Rep 193
Posts |
That is what I would exepect - as its talking to the ECU - and nothing has chanaged on the ECU.
As your racechips changes the settings between the ECU and the engine - similar to an JB4 works. So you need to communicate to the racechips for datalogging. That would be my logic on the matter The only way you could test your increase in power is using somthing like an accelerometer that users your GPS and works out the power. I have used one - but use it as an guide
__________________
E89 28i (14)
e92 335i (sold) e46 330D (Sold) e46 220D (Sold) |
Appreciate
0
|
Post Reply |
Bookmarks |
Tags |
28i, dash command, n20 |
|
|