|
|
03-04-2014, 10:54 AM | #1 |
Major General
146
Rep 5,104
Posts |
errors after gruppe m rep intake
These are he errors:
Engine module Current Fault Codes 29E1: 29E1 fuel mixture control 2 Error will cause a warning light Error is not currently present Test conditions have been completed Signal or value below threshold Freeze Frame Information Odometer 52728kms 32763miles Engine temperature 101.25 °C air mass calculated 293.00 mg/stk Engine speed 1,600.00 rpm matching inlet valve model (factor) 1.13 - 29E0: 29E0 fuel mixture control Error will cause a warning light Error is not currently present Test conditions have been completed Short circuit or signal interruption Freeze Frame Information Odometer 52776kms 32793miles Engine temperature 51.00 °C air mass calculated 108.52 mg/stk Engine speed 640.00 rpm matching inlet valve model (factor) 1.04 - Gearbox control unit Current Fault Codes CF35: Messages from CAS don't exist Error will not cause a warning light Error is not currently present Test conditions have been completed Timeout Dynamic stability control DXC8 Plus - E90 Current Fault Codes D35A: PT-CAN: Message KLEMMENSTATUS (ID 0x130) not received. [transmitter:CAS] Error will cause a warning light Error is not currently present Test conditions have been completed Timeout Footwell module (FRM)for vehicles up to 09/2006 Current Fault Codes A8C5: Error will not cause a warning light Error is not currently present Test conditions have been completed Timeout Instrument cluster PL2 E8x and E9x Current Fault Codes A3B2: CAN ID 130 error: Clamp status Error will not cause a warning light Error is not currently present Test conditions have been completed and here is the previous post for the weird feeling and pic http://e89.zpost.com/forums/showthread.php?t=950725
__________________
|
03-04-2014, 01:49 PM | #2 |
Major General
146
Rep 5,104
Posts |
now I change back to oem intake. The rpm still drops to 300 to 400 (almost stall) when I stop at the traffic light. Should I take it to dealer with all the error codes or should I just reset everything with BT tools and wait to see if they will pop up again?
__________________
|
Appreciate
0
|
03-04-2014, 02:40 PM | #3 |
Major General
146
Rep 5,104
Posts |
More problems.
1. Roof start leaking during the rain 2. 1 of the AE out 3. 1 of the window will automatically roll down when I want it up What a great day for me.
__________________
|
Appreciate
0
|
03-04-2014, 03:28 PM | #4 |
Private First Class
21
Rep 125
Posts |
Feel for your brother, that grupe m intake that you adapted to the Z, did it have a filter since you adapted it to the Z? Just curious. If there was no filter it could have sucked in something detrimental to the engine. Man that's alot of gremlins that suddenly shows up. I don't think an intake alone does that, but I can be wrong.
__________________
Cobb AP3 map Stg2+FMIC LT Aggrssv:::ER FMIC & ChargePipe w HKS BOV:::AFE Stage 2 sealed
ARDesign Downpipes w race cats:::Eisennman Quad Race:::KW V1:::M3 Control and Thrust Arms |
Appreciate
0
|
03-04-2014, 03:39 PM | #5 |
Major General
146
Rep 5,104
Posts |
yes, it does have the filter. The car felt like too much air sucked in, just like running without the airbox.
And yes, those are not caused by the intake itself. Especially the roof leaking, window issue and AE burn out. hahahaha.
__________________
|
Appreciate
0
|
03-05-2014, 07:46 PM | #6 |
Private
2
Rep 68
Posts |
My car idled low like that too. Took it to BMW and they replaced all my injectors under warranty. I think it's a common problem. Not sure what to tell you about the roof.
|
Appreciate
0
|
03-11-2014, 12:25 PM | #7 |
Major General
146
Rep 5,104
Posts |
got the car back from dealer.
1. They updated the software according to TSB to fix the stall and low RPM problem, also raise the idle RPM 100 higher 2. recharged the battery and re-initiated the window to fix the window auto down to 1/3 position (they recharge my battery twice within 3 months) 3. Changed out the h8 bulb for AE 4. found intake elbow clamp not tight enough, caused fuel mixer #1 & #2 error, re-tight (I think that's bs, I checked it twice before I send my car in) 5. transmission error due to low voltage 6. cluster error due to low voltage 7. performed ultrasonic test on the roof, can't find the leak... 8. can't find what's wrong with auto headlight leveling sensor, re-adjust to the spec They gave me 4 pages long description for this service, including change out my micro filter and brake fluid. I have bad feeling about that battery, because this car been sitting in the lot for more than 3 months before they sell it to me. We will see if more error will pop up within few weeks. They gave me a loaner with almost empty tank, and asked me to bring it back with same level, which is impossible. When I return the loaner 4 days later, I gave them more than half tank. SA is great, not sure about any others.
__________________
|
Appreciate
0
|
03-11-2014, 02:18 PM | #8 |
Private
2
Rep 68
Posts |
I would replace my battery if it is giving you problems. You can buy them at costco or Walmart for under a hundred bucks. Might save you a lot of problems later on.
|
Appreciate
0
|
03-11-2014, 02:45 PM | #9 |
Major General
146
Rep 5,104
Posts |
SA said if the battery give me problem one more time, they will replace it for me under warranty. So I will use that $100 for some beers just for now. hahaha.
__________________
|
Appreciate
0
|
03-11-2014, 02:55 PM | #10 |
Lieutenant General
3183
Rep 10,509
Posts |
Did they check out the headlight leveling sensors attached to the suspension?
the roof shouldn't leak, that should be fixed for sure. I am able to take my car into high pressure spray "touchless" car washes without any issues |
Appreciate
0
|
03-11-2014, 02:57 PM | #11 |
Major General
146
Rep 5,104
Posts |
On paper, they didn't mention to check the sensor. But they told me verbally the sensor was checked.
__________________
|
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|