Quote:
Originally Posted by Hedders
Well, look at what just arrived in the post.
Attachment 3419802
Attachment 3419801
Attachment 3419803
They look REALLY good!
It's horrible outside so I will fit them later.
ETA: I have just discovered there are little nubs on the metal bar that poke into the brackets. Do you guys just cut the nubs off as there is no allowance for them in the 3D print? |
Looking good mate!
I just discovered those nubs today. It messed with my off the cuff design big time.
Nub came off with a screwdriver twist, and you lot have me doing a redesign of my quick zip tie fix. So much for a 20 minute solution.
I'll polish the file a bit before posting, but now it's even simpler. Only two bolts counter sunk. Not new, but improved?
Observe, adapt, overcome.
Cheers!
George