Quote:
Originally Posted by jts1981
Hello again,
I've been researching wheels and I see 19x10 with offset of 22(e46 m3 fitment), and offset 37, see link
http://www.wheeldude.com/wordpress/tag/19x8519x10
My question is why are both numbers so off? and also which set up would provide the deeper lip? I am assuming the 22 offset, but when you look at the photo of a 37 offset the lip looks as big, maybe even bigger...
any thoughts?
|
the lower the offset, the larger the lip will be
Quote:
Originally Posted by javol
IMO your wheels stick out 1 cm more or less, especially the rear ones...
If the aim of the thread is to give infos to the forum about the "exact numbers of ET and widht" to have the wheels flushing the fenders i believe my numbers are more accurate than yours...
Anyway, i'm not criticizing your car, it is just a clarification
|
wouldn't it rub if i go over big bumps if it is sticking out? i don't have that issue. my car is lowered now and it is tucking inside the fenders. i only had to trim the fender liner a little bit to clear the tires. no other mods on the car to clear it