|
Did you use the diagnostic LED on the module to verify it was installed correctly?
The green LED on the module should light briefly when the module is first installed. Then you need to do something to wake up the CAN bus like hitting a button in the remote. This should cause the LED to blink for a while.
To program using the turn signal you need to turn the ignition on then off. On a non CA car this required inserting the key & pushing the start button a few times. On a car with CA I don't know how you do that since inserting the key is optional I think. But net-net the instructions say to cycle the ignition on/off before using the turn signal to engage programming mode. It also says to only move the stalk to the "lane change" position until the turn signal arrows light to initiate programming mode.
|