[rking117]

where the holes are rounded and sticking out of the bumper if you want to use another method instead of sanding you can use a air dryer and heat the area then use a nail cuticle tool to press the edges inward. Then go to your filling step. This will be much much faster and will result the same in the end. Be very careful not to get it too hot though a the bumper is made of heat sensitive material it could crack your paint. I had my sister run over a mailbox with my Fiat and it left a big dent n the bumper. A heat gun and a little bit of bondo fixed it right up. Then sprayed the area nd blended it and it was like new. Again use a ar dryer not a heat gun. And also make sure the you dont get it too hot. Just to where it feels hot to the touch not scorching hot. anything hotter will cause it to shrink or expand.