Thread: Meth injection
View Single Post
      10-21-2014, 07:43 PM   #19
Hujan
Brigadier General
Hujan's Avatar
United_States
569
Rep
3,742
Posts

Drives: M3
Join Date: Apr 2013
Location: .

iTrader: (16)

Probably under the car.

If I were going to do meth, it would probably be a trunk mount tank and pump, and I would think very seriously about using an Aquamist system that runs off duty cycle and boost, rather than just boost. I would probably run 70/30 meth to water, and I either wouldn't tune for it or, if I did run a tune specifically for it, I would only load one with a Cobb flash tuner and only on special occasions.

Also, if you are running meth, I don't see any reason not to use a DCI. The DCIs have the advantage of more air flow, but with the drawback that it is hotter air. But the combination of meth and a good FMIC will easily cool that air back down to ambient. In other words, you're leaving a lot of cooling capacity on the table by running a sealed CAI.
Appreciate 0